You must use seq/ack analysis to identify the initial roundtrip time taken for any connection.
How to calculate initial round trip time for any TCP Connection
Popular Posts
-
Palo Alto Configuration Backup Step1: Navigate to Device > Setup > Operations after login into palo alto firewall. Step2: ... -
Step1: Change the hostname of the Aruba Switch using the following command: ( Command is similar to Cisco Switches) Switch# Switch#Configur... -
Differences between IKEv1 and IKEv2 --> IKEv2 is an enhancement to IKEv1. --> IKEv2 does not consume more bandwidth compared to I...
-
--> We basically use DHCP option 43 and option 60 in wireless networks for Access Points and Controllers. --> Option 43 helps an A...
-
--> Flex Connect is a wireless solution which allows you to configure & control access points in remote/branch offices without confi... -
To check BIGIP version : tmsh show /sys version To check BIGIP hardware and serial number : tmsh show /sys hardware To check self IP ad... -
Q) What is the use of HSRP? A: HSRP is used to provide default gateway redundancy. Q) What is the maximum number of HSRP groups that c... -
Basically VSS and Vpc both are used to create multi chasis etherchannel 1) vPC is Nexus switch specific feature,however,VSS is created u...
-
Following are the failure scenarios we are going to discuss below: 1) vPC Keep-Alive Link is Down --> Nothing happens if the Keep-Alive... -
STP is used to avoid switching or bridging loops in the network. If STP is disabled on any one of the switch Loops will occur. In this post...
0 comments:
Post a Comment