--> Login into Riverbed Console and execute the following command to do the initial configuration:
--> By default, The Primary Interface of Riverbed is DHCP enabled on it.
--> Connectivity of Riverbed:
Steelhead to any Non-Switch Appliance ( Router/Firewall): Crossover Cable
Steelhead to any switch appliance: Straight-Through Cable
Riverbed > enable
Riverbed # configure terminal
Riverbed (config)# configuration jump-start
Step1: Hostname? [BR-SH01]: Branch-SH01
Step2: Use DHCP on Primary Interface? [Yes]: Yes
Step3: Admin Password? [] (default password:password)
Step4: SMTP Server? []
Step5: Notification Email Address?
Step6: Set the primary interface speed? [auto]
Step7: Set the primary interface duplex: [auto]
Step8: Would you like to activate the in-path configuration: yes
Step9: Inpath IP address: 10.1.1.3/24
Step10: In-Path Netmask: 255.255.255.0
Step11: In-Path Default gateway: 10.1.1.1
Step12: Set the in-path: LAN interface speed: auto
Step13: Set the in-path: LAN interface duplex: auto
Step14: Set the in-path: WAN interface speed: auto
Step15: Set the in-path: WAN interface duplex: auto
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
0 comments:
Post a Comment