--> Firstly check NAT inside and NAT Outside are applied on the correct interface, by using following command.
# show ip nat statistics
--> If Nat Inside and Nat Outside are correct then check whether the access-list which is mentioned in NAT configuration is correct.
# show ip access-list
--> If access-list configured is correct then check whether the NAT translation is happening or not
# show ip nat translations
# show ip nat statistics
--> If Nat Inside and Nat Outside are correct then check whether the access-list which is mentioned in NAT configuration is correct.
# show ip access-list
--> If access-list configured is correct then check whether the NAT translation is happening or not
# show ip nat translations
0 comments:
Post a Comment